The position transducer is integrated in the cylinder. The measuring bar is located in the hollow-bored piston rod, the electronic tubus is surrounded by a protective tube.
If necessary, replace the seal (o-ring / flange seal) [4] or the entire position transducer [3].
The magnet installed on the piston rod does not need to be replaced if the position transducer is replaced with an identical design.
|
|
The required hook wrench B 68-75 according to DIN 1810 is available from Hänchen. You can find it under tools in our Product configurator HÄKO.
|
|
The version with a closed protective tube offers the option of mounting additional accessories, such as a rod eye spherical.
The required mounting wrench is available from Hänchen. You can find it under tools in our Product configurator HÄKO.
|
|